Skip to content

What to Do When a Pipe Bursts in Your Colorado Springs Home

By Incline Plumbing & Drain · Colorado Master Plumber license MP.00189484 ·

When a pipe bursts, shut off your main water valve first. Then keep clear of any water near outlets or cords, open your faucets to drain the lines and move your things out of the wet area. Take photos for your insurance. Then call a licensed plumber to fix the pipe.

Why This Matters

A burst pipe can push out a lot of water in a short time. That water soaks into floors, walls, carpet and cabinets. The longer it runs, the more damage it does.

The steps you take in the first few minutes make a big difference. Most of them need no tools and no plumbing skill. You just need to know where your shutoff valve is and what to do next.

In Colorado Springs, many burst pipes happen in winter. Warm, sunny days and hard-freezing nights can come in the same week. Pipes in outside walls, crawl spaces, garages and unheated spaces are most at risk.

This guide walks you through each step in order. Read it now, before you need it. Then go find your main shutoff valve so you are ready.

Step 1: Shut Off the Main Water Valve

Your first job is to stop the water. Every home has a main shutoff valve that controls the water to the whole house. Turning it off stops the flow to the burst pipe.

Where to Find Your Main Shutoff

The main valve is usually where the water line enters your home. Look in these spots:

  1. In the basement, on the wall that faces the street.
  2. In a crawl space, near the front of the house.
  3. In a utility room, often near the water heater.
  4. In the garage, on a wall near the front.
  5. Near the kitchen sink in some slab homes.

How to Turn It Off

There are two common kinds of valves. A round wheel valve turns clockwise to close. You may need to turn it several times. A lever valve turns a quarter turn. When the lever sits across the pipe, it is closed. Once the main is off, the leak will slow and stop. Some water will still drain out of the pipes, which is normal.

If the valve is stuck, do not force it hard enough to break it. Some homes also have a shutoff at the curb or meter. In many cases, that one belongs to your water provider. Call them if you cannot close your own valve.

Find your main valve now, while the floor is dry. Make sure it turns. Show everyone in the house where it is.

Step 2: Stay Safe Around Water and Power

Water and power do not mix. Before you step into a wet room, think about where the water is going.

Check for Electrical Risk

Look for water near outlets, power strips, cords, lights or appliances. Water dripping from a ceiling may be passing near a light fixture. Water on the floor may reach a plugged in lamp or heater.

Keep these rules in mind:

  1. Never stand in water while touching anything electrical.
  2. Do not unplug items while you are standing in water.
  3. Stay out of rooms where water reaches outlets or cords.
  4. Keep kids and pets away from the wet area.

Turning Off the Power

If you can reach your breaker panel from a dry spot, switch off the breakers for the wet area. If the panel is wet, or you have to walk through water to reach it, leave it alone. Call an electrician or your electric utility for help.

A burst pipe is stressful, and it is easy to rush. But no amount of water damage is worth a shock. Take a breath and make the area safe before you start any cleanup.

Step 3: Drain the Lines and Move Your Things

With the main valve off, there is still water sitting in your pipes. Draining it takes pressure off the system and limits how much more leaks out.

Drain the Pipes

  1. Open the lowest faucet in the house, such as a basement sink or outdoor faucet.
  2. Open the faucets on upper floors to let air into the lines.
  3. Flush each toilet once to empty the tanks.

Protect the Water Heater

If the water will be off for a while, check your water heater. Many units have a vacation or pilot setting. An electric unit can be switched off at its breaker. Follow the label or the owner's manual for your model.

Move Your Things

Next, get your belongings out of harm's way. Start with what is hardest to replace.

  1. Move papers, photos and electronics to a dry room.
  2. Roll up rugs and lift them off wet floors.
  3. Set furniture legs on blocks or foil to keep them off wet carpet.
  4. Pull boxes up off basement floors.

Mop up standing water with towels or a wet vacuum. Open windows and run fans if it is safe to do so. Wet drywall and carpet can grow mold if they stay damp, so drying matters.

Step 4: Take Photos for Your Insurance

Before you clean too much, take photos. Good records help when you file a claim with your home insurance.

Many homeowner policies cover sudden water damage. But every policy is different. Call your insurance company to ask what yours covers and what they need from you.

What to Photograph

  1. The burst pipe itself, close up and from further back.
  2. Water on floors, walls and ceilings.
  3. Water lines or stains on drywall and baseboards.
  4. Each damaged item, with a note of what it is.
  5. The rooms before and after you start drying them.

Take video too. Walk slowly through each wet room and talk through what you see. Phones save the date and time, which helps. Take a few shots of the main valve too, to show you shut it off.

Keep Good Records

Do not throw out damaged items until your insurer says it is okay. They may want to see them. Keep receipts for anything you buy for cleanup, like fans or towels. Save any notes, emails and estimates in one place. When the plumber fixes the pipe, ask for a written record of what was done.

Step 5: Call a Plumber During Business Hours

Once the water is off and the area is safe, it is time to fix the pipe. A burst pipe needs a proper repair, not just tape. A licensed plumber can find the break, fix it and check the nearby pipe for more damage.

Our hours are Monday to Friday, 7am to 5pm. With your main valve off, the leak is stopped while you wait. Keep it off until the pipe is repaired. When we arrive, we follow the same three steps on every job:

  1. Diagnostic Assessment. We find the break and check the pipe around it.
  2. Upfront Strategy. We explain the fix and give you an estimate first.
  3. Precision Execution. We make the repair and test it with the water back on.

Our crew wears shoe covers and keeps a clean workspace, which matters in a home that just had a flood. Learn more about pipe repair in Colorado Springs.

How to Prevent Burst Pipes Next Winter

Many burst pipes in our area start with a freeze. Water expands as it turns to ice. That builds pressure inside the pipe until it splits. Often the leak shows up only when the pipe thaws.

Before the First Hard Freeze

  1. Disconnect garden hoses from outdoor faucets.
  2. Shut off and drain outdoor faucets if they have an inside valve.
  3. Ask about a freeze-proof outdoor faucet for spots that keep freezing.
  4. Insulate pipes in crawl spaces, garages and outside walls.
  5. Seal drafts near pipes, like gaps around vents and sill plates.

During a Cold Snap

  1. Keep the heat on, even when you are away.
  2. Open cabinet doors under sinks on outside walls.
  3. Let a faucet on an outside wall drip slowly overnight.
  4. Keep the garage door closed if pipes run through it.

Homes at higher elevation face colder, snowier winters. If you live up north on the Palmer Divide, our plumber in Monument page covers local tips. Older homes with pipes in outside walls may need extra insulation, or new pipe routes. That is part of our pipe repair services, which include burst and frozen pipes and repiping.

What Does Burst Pipe Repair Cost?

There is no set price for a burst pipe. The cost depends on the break and where it is.

  1. Where the pipe is, such as in a wall, ceiling or crawl space.
  2. What the pipe is made of.
  3. How many breaks there are.
  4. Whether nearby pipe is also worn and should be replaced.

We also look at the pipe around the break. If one spot burst, nearby pipe of the same age may be weak too. We will tell you what we see and let you decide.

Fixing drywall, floors and cabinets is a separate job from fixing the pipe. We use upfront pricing with no hidden fees, and you get an estimate before any work starts.

When to Call a Professional

You can and should do the first steps yourself. Shutting off the water, moving your things and taking photos are all homeowner jobs. But the repair itself is a job for a licensed plumber.

Where DIY Should Stop

  1. Do not try to solder or cut pipe if you have not done it before.
  2. Do not thaw a frozen pipe with an open flame or torch.
  3. Do not turn the water back on until the pipe is repaired.
  4. Do not go near wet outlets, cords or a wet breaker panel.

If a pipe is frozen but not burst, you can try warming it gently with a hair dryer. Keep the faucet open as it thaws. If you cannot find the frozen spot, or it is inside a wall, call a plumber. We hold a Colorado Master Plumber license and are fully insured.

Need a Plumber in Colorado Springs? Incline Plumbing & Drain Is Ready to Help

We are a locally owned plumber based on the Westside of Colorado Springs. We fix burst and frozen pipes and give you an estimate before any work starts. Our hours are Monday to Friday, 7am to 5pm.

Call (719) 922-3350 or contact us online.

Questions About Pipe Repair & Repiping

In most homes it is where the main water line comes in, often on a basement or crawl space wall, near the water heater or in a utility room. Some homes also have a valve near the meter outside. Find yours now and make sure it turns, before you need it.

Sometimes, but do not count on it. Ice can split a pipe while it is frozen, and the leak only shows once it thaws. Open the faucet, warm the area gently with a hair dryer or a space heater kept at a safe distance, and never use an open flame.

Repiping means replacing old water supply lines with new pipe, often PEX, a flexible plastic pipe used in most newer homes. It can cover one part of the home or all of it. We plan the route with you, and you get an estimate before work starts.

Back to all plumbing tips

Talk to a Colorado Springs Plumber

Call Mon to Fri, 7am to 5pm. You get a clear plan and an estimate before any work starts.

Mon to Fri, 7am to 5pm